Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
Hello,

I'm building my first street rod, a '50 Chevy Pickup, and I'm ready to start on the engine.

I have an early '70's 010 4-bolt 350 SBC block (free) that I would like to use. My target is approximately 400HP for this motor. I plan on making this motor a 383 stroker. Not sure yet if it will have fuel injection or a supercharger. This truck will be a driver, not a trailer queen.

My question is with core shift. I have measured the cam bores front and rear and it looks like I have about 0.100" core shift in this area. Is this too much? Should I ditch this block and look for something else? I would hate to spend the machine shop budget on a block that should not have been considered in the first place.

Thanks in advance,

H2Os50
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top