Hot Rod Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
305 Posts
Discussion Starter · #1 ·
I have a 1982 chevy p.u that is in need of a new engine. The original engine is a 305 4 barrel. I have a 350 I'm going to install. The 350 has only about 1,000 miles on it but it's been sitting for about 5-6 years. SHould I go completely through the engine just to be sure? Also, I would like to build it a little hot but not too hot for the street. I thought about grinding the rods to be equal weight, what do you think? Any other advise would be apprciated
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top