Hot Rod Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
hey im using an epoxy sealer and I'm having trouble getting it to spray.I believe its to thick,should i thin this? i am using a ingersoll rand gravity feed gun.I think the needle valve is a 1.4. I do have a chepo primer gun. This type sealer may not need to be thinned.Not sure. any info would be greatly appreciated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top