Hot Rod Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
118 Posts
Discussion Starter #1
Well, my Newbie is showing again .....

I bought a Crate 350 and I am in the process of putting on the trinkets. I purchased after market Block Huggers. The ports on the Block are square. The Block Hugger are round at the mounting flange. They are the same size, but have a little overlap. Will that cause any problem ? and what gasket do I use ?

Do I use the gasket that matches the ports on the block ? Thanx in advance for any help.
 

·
Hates: Liver. Loves: Diesel
Joined
·
5,659 Posts
For all-our max power, you might gain a few hp if they were matched, but I wouldn't worry about it for a split second. No troubles, just 2 hp :)
 
1 - 2 of 2 Posts
Top