Hot Rod Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
121 Posts
Discussion Starter · #1 ·
Well, my Newbie is showing again .....

I bought a Crate 350 and I am in the process of putting on the trinkets. I purchased after market Block Huggers. The ports on the Block are square. The Block Hugger are round at the mounting flange. They are the same size, but have a little overlap. Will that cause any problem ? and what gasket do I use ?

Do I use the gasket that matches the ports on the block ? Thanx in advance for any help.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top