Hot Rod Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
1,347 Posts
Discussion Starter · #1 ·
im going to be pulling the engine out of my twin turbo iroc soon and will put it up for sale on my local forums problem is i dont know how much to ask

its a fresh sbc 355 about 500 miles on it

gm forged crank std/std
gm rods that have been resized shot peened strees relived with arp waveloc bolts
speed pro popup pistons 9.2-1 cr
summit 224/224 cam and edelbrock 234/244 cam edl currently installed
ported 882 heads , stainless valves
port matched tpi intake

i will also be in cluding the twin turbo headers but no turbos or wastegates.
along with that ill be selling ir without injectors

so basically a complete longblock and a set of twin turbo headers

i was thinking around 1,200 bucks sound fair? or is that to cheap/expensive for what it is
 

·
Banned
Joined
·
2,474 Posts
unless you plan on getting 300.oo I'd leave it in the car so the buyer can hear/see it running..
low miles or not.. if I can't see it run.. it's a core as far as paying money to buy it..
receipts for the parts/machine work will help..
1200.oo isn't out of line if you have proof of the work and parts..
but at 1200.oo I want to hear it run.. and be able to pull the pan and look at a main bearing..
good luck..
 

·
Registered
Joined
·
2,403 Posts
i kinda agree with gearhead

hearing it run is big... i'd never put that money into a motor i can't hear.. but if u want to pull the pan and ck the bearings???
U BETTER B BRING'N A PAN GASKET TOO... or no dice..
 

·
Registered
Joined
·
1,347 Posts
Discussion Starter · #6 ·
thaks guys i put it up for sale now so potential buyers could hear it runin the car / go for a test drive if ti dosent sell before i pull it ill build a lil engine stand it can be run on.

only thing i dont have paper work for is the rods , but it is obvious if u pull the pan off

if the engine dont sell ill prolly drop it in my silverado 2500 with a milder cam
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top