Hot Rod Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Can anyone direct me to information about drilling the steam holes in the fast burn heads. I read the post about the 30 degree angle for the one set, but in a different artical, the author said 45 degrees. I have centerpunched these brand new heads, but can't bring myself to drill yet ! thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top