Hot Rod Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
I am working in a garage in NE Ohio. The furnace stays at 50F, except when I am working and I turn it up to 60F. Can I apply filler in this climate? The filler I am using is Evercoat Rage. It says the setting time is 5-6 minutes @ 75F to 80F. Any help would be greatly appreciated.

Thanks
 

·
Brian Martin,Freelance adviser
Joined
·
16,376 Posts
Do a few test panels to get the amount of hardener needed, it will cure.
 

·
Glad the Jeep is on the road
Joined
·
809 Posts
I've done a lot of boat repair with the 3M marine filler (very similar stuff) and it does OK to about 55 degrees in my experiments. I'd be worried going much colder.
 
1 - 4 of 4 Posts
Top