Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter · #1 ·
Looking for help- again. I cannot find any info on torquing the bolts holding on my flex plate. I am putting together a SBC and am about ready to mate the tranny and motor together to mock up mounting brackets etc. does anybody know what torque levels should be used when installing the flex plate? Should I use lock tight? There weren't any lock washers with the flex plate, only the mounting bolts. I appreciate any help you folks can provide. Thanks in advance. Mike
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top