Hot Rod Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
104 Posts
Discussion Starter · #1 ·
I'm about to finish my floorboards in my '39 Ford two door sedan. It's channeled over an S10 Blazer frame so I made my own. They are welded in and seam sealed. Should I just do the Rustoleum thing or is some other paint better? Should I put 1/4 inch insulation on them? I also have to old insulation and from the S10 Blazer if something like that would do. Thanks in advance, Rod
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top