Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi, I have a 1970 LTD with a 351W and FTX. I'm switching out a 68 390FE and trying to keep the FMX (I don't trust myself modifying the driveshaft and crossmember to put in a C6. Does anyone know where I can get an FE bellhousing for the FMX to fit the 390 or exactly what I need to do to modify the driveshaft and crossmember for the C6?

Thanks a lot,
Michael
 

·
Administrator
Joined
·
10,121 Posts
C6 trans will bolt in place of the FMX in many situations.

Since you are installing a different engine , a different trans does not seem that difficult to swap out too.

I would suggest a look see if the C6 will mount in the same location to keep the drive shaft the same length and them build some engine mounts as needed
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top