Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I am going to rebuild my 351W from my '86 E-350 4X4 Van. Should I "blueprint" the engine? Should I modify any components for better performance for my massive 4X4? What are the best resources to use for this job? I'm looking for documentation, step by step guides, and some solid recommendations for this project (my first project).

Thank you in advance for any helpful advice!!!
 

·
http://www.warsprints.com
Joined
·
2,024 Posts
4XVAN said:
I am going to rebuild my 351W from my '86 E-350 4X4 Van. Should I "blueprint" the engine? Should I modify any components for better performance for my massive 4X4? What are the best resources to use for this job? I'm looking for documentation, step by step guides, and some solid recommendations for this project (my first project).

Thank you in advance for any helpful advice!!!
As far as blueprinting, that's not necessary but balancing it is.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top