Hot Rod Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
196 Posts
Discussion Starter · #1 ·
hi all . i have done a something silly .

all my wiring hadnt been cleaned up and now that i have got my engine running i decided to clean up all the wiring and also tape it all up and clip to the chassis and tidy it all . during this some of the wiring needed to be sorted out and untangled. so i did that. and then got in a pickle and had to refer to the owners manual of my 1967 ford mustang and find which wires were to go to the regulator . it now doesnt charge !! doh .

does anyone know and easy way to fix this without undoing hours of work ? ie is there a simple diagram i can follow from the alternaor to the "seperate"regulator to get it charging . its not the connections as i have checked all of them and all the fuses are ok so its all looped in and should be charging.

what a numpty :(
 

· Registered
Joined
·
196 Posts
Discussion Starter · #5 ·
thanks for the links. and they are alot easier to follow in the link you sent. funny though as i have the diagram in the workshop manual the same and thought i followed it . well looks like im going back and checking which goes where.

thanks for your help guys
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top