Hot Rod Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
I am going to be welding some C-Notches on my
S-10 frame real soon. My question is- I have a small Lincoln mig welder that says it will do 1/4 inch metal with flux cored wire. I am wondering if I would be ok welding the 3/16 notches to my 3/16 frame with this welder, or would I be better off using a stick welder?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top