Hot Rod Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,111 Posts
Discussion Starter · #1 ·
I have a 26T with a 3 piece hood.It hinges on the right side since the top is attached to the one side cover I can't run with just the top part as I would like to sometimes.Does any one have plans to make the hood hinges that makes it go up and tilt forward? Or any suggestions? And please don't tell me where I can BUY set-ups for $3or$400.00..
 

·
Registered
Joined
·
1,111 Posts
Discussion Starter · #3 ·
I don't think I can use any stock hinge because a Model T has nothing in fron to bolt to.I thought I saw one somewhere that had flat or angle running from the radiator cover back to the firewall on both sides and some kind of hinge set-up attached to them,but I don't remember where I saw it or any details
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top