Hot Rod Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
41 Posts
Discussion Starter · #1 ·
Can anyone point me to a gasket material sheet or tube that is fuel resistant? I cannot seem to find a gasket sealer that says specifically that it is resistant to fuels. Plenty say resistant to oil or 'shop fluids'. But I am looking for something specifically to seal the lid of a fuel cell.

Thanks,
Jeff
 

·
Registered
Joined
·
41 Posts
Discussion Starter · #5 ·
Thanks. After I posted this I was thinking, heck I am sure there is some Permatex product that is fuel resistant. So I searched but couldn't find any. I will look for those products.

jeff
 

·
Registered
Joined
·
41 Posts
Discussion Starter · #7 ·
I was just reading up on them. I think #2 is going to be the best for my application. Thanks a bunch. This does exactly what I was looking for.

Jeff
 

·
Registered
Joined
·
41 Posts
Discussion Starter · #10 ·
I've used the Right Stuff. I didn't think it was fuel resistant though.

It's a custom cell so I have nobody I can turn to where their gasket would fit.

Thanks guys, the #2 should do the trick.

Jeff
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top