Hot Rod Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I recently installed an Ididit steering column in a 39 Buick, since the install I have been losing power to sections of the fuse panel. It started at the bottom and is going up the panel. The fuses do not blow but there is no power to them. Ideas? Is there a fusible link or something similar that anyone knows about? The car still starts and runs.
Steve
 

·
Registered
Joined
·
7,345 Posts
Doc here, :pimp:

If it's traveling up the buss, I'd look at the buss bars for a broken solder joint (s)..Pull and inspect the rear of the buss .

A link would take out "spotty" fuses all over the buss..a bar would travel in a line..

Doc :pimp:
 
1 - 3 of 3 Posts
Top