Hot Rod Forum banner
1 - 5 of 5 Posts

·
Premium Member
Joined
·
2,370 Posts
Discussion Starter · #1 ·
Anyone know what OHMS range a gas tank sending unit would be (stock) in a 66 GMC pickup? 0-90 ohms, 70-10ohms, 30-180ohms or 240-33ohms? I am getting a new fuel guage but I want to make sure I am getting the right one.

Worst case I suppose I could pull it and measure the ohms based on the leaver being full and empty but I would like to avoid doing that if possible.

Thanks a bunch.

Dylan.
 

·
Registered
Joined
·
340 Posts
I agree, but this only applies if you are getting a stock GM replacement gauge. If you are getting an aftermarket gauge, it might differ by manufacturer but it should be marked and you can match it to your stock sender.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top