Hot Rod Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
44 Posts
Discussion Starter · #1 ·
i just replaced the blown head gaskets on my sbc 350. i set the valves(i think correctly) and its having trouble starting. I primed the carb and it turns over very rough and runs very very hard for 2 seconds and dies. Im not sure if thats due to incorrect valve set or the distributor. i hope im really close to getting this truck running again. Any suggestions at all is a help. Thanks in advance.
 

·
Registered
Joined
·
2,403 Posts
ck timing for sure

if u have a manual there is or should be, a part that tells u which valve to adjust at TDC and one full turn of crank. have u tried to adj the diz when it's kinda running.. gotta be fast if it's not going to stay.. but u put the diz in correctly it just sounds like it's off.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top