Hot Rod Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
I am installing my Herman headers tomorrow on my profiler heads. My question is the exhaust ports are d shaped and the primaries are oval shaped. Should I use the gaskets which came with the headers which will partially be in the exhaust path or should I get a set of gaskets that are the same size as the exhaust port
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top