Hot Rod Forum banner
1 - 2 of 2 Posts

· Race it, Don't rice it!
Joined
·
9,750 Posts
Ive pumped the cylinder full of air before to lift a head. 175psi might help.
IF you can get the studs out, stick something in the intake port and pull.
If you wanting to save the studs, this won't work but you can thread on a nut and weld it on the stud. The heat and move down the stud and break the bond and the nut will give ou something to grab onto.
 

· Race it, Don't rice it!
Joined
·
9,750 Posts
That reminds me of a time putting in a new dist on a 69 Ford pickup, on the side of a gravel road on top of a river levy that was blocked off due to flooding.
Stupid thing didn't fit so a buddy grabbed a 2 foot piece of scrap 2x4 and a 2lb hammer and drove it ALL the way in, timing unknown......Ran great for another bunch of years that way and ultimately that old ford ended up under water and as far as I know, still there......ironically.
Do what ya gotta do some days
 
1 - 2 of 2 Posts
Top