Hot Rod Forum banner
1 - 5 of 5 Posts

·
Duck Tape & WD 40
Joined
·
278 Posts
I dont know about a camaro but I just put a new heater core in my truck. all I had to do was take out the glovebox and then all the stuff behind it then just changed it. as you can tell i'm not very good at describing how I did it. but?
 

·
Registered
Joined
·
10 Posts
Discussion Starter · #5 ·
Thanks for the information on your truck.
I think you are right on bringing it out through the
glove box area. I was in hopes that it could be done via the
engine side of the firewall without removing the fender.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top