Hot Rod Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I have a 54 ford car 239 eng. trying to put a 1960 ford dist. will this work in this 239? the 239 has got a slot dist.rod in it now so i fount a hex rod that will work in the 1960 dist. how long will it need to be to work??? can i put the dist. in a see how it needs to be to fit on the oil pump it is 8'' long. the gear on the 60 dist.is bigger will the old one fit back on it too?

thanks i hope you can under stain this :confused:
thanks for your HELP ON THIS Bob t
 

·
http://www.warsprints.com
Joined
·
2,024 Posts
btull said:
I have a 54 ford car 239 eng. trying to put a 1960 ford dist. will this work in this 239? the 239 has got a slot dist.rod in it now so i fount a hex rod that will work in the 1960 dist. how long will it need to be to work??? can i put the dist. in a see how it needs to be to fit on the oil pump it is 8'' long. the gear on the 60 dist.is bigger will the old one fit back on it too?

thanks i hope you can under stain this :confused:
thanks for your HELP ON THIS Bob t
What size motor out of the 1960?
 

·
WFO
Joined
·
5,030 Posts
If your 289 distributor uses an O-ring to seal it, the conversion can work. You will need to replace the 289 gear. If your car is 6V, the condenser will need to be changed to a 6V one for the 289 distributor, I believe.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top