Hot Rod Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
46 Posts
Discussion Starter · #1 · (Edited)
I have a Holley carb that has had the air horn milled off and some serious work done to the venturis. By the venturi size and the throttle bore size it is a 750 cfm. In the area milled down it has the name Flo Tec. Does any one know who they are, or even if this is a legit modifier? The Cyl heads have the same name on the ends.
 

·
Registered
Joined
·
46 Posts
Discussion Starter · #3 ·
The carb is on a 64 Chevelle. 355 CID Lunati crank, Manley rods & pistons, crane 580 lift roller with 238 duration @ 0.50. I took the manifold off to seal up the oil leak and the heads have been hogged on. The edelbrock scorpion manifold also. I have it back together and it is a monster. The owner and I are going to the strip with is in a couple of weeks. We will see??????
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top