Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
107 Posts
Discussion Starter · #1 ·
Hello I finally got around to getting my guns cleaned properly and spraying. I used my new gun today which recommended a higher pressure 50psi and consequently I got a few runs on the first coat. I sprayed dupont centari single stage acrylic enamel.

-I need to know how long do I have to wait before I can sand it smooth and repaint over the runs?

-Here is the tech sheet if that helps. I couldn't find the answer on here but I am new at this so it may be there.

http://pc.dupont.com/dpc/en/US/html/visitor/common/pdfs/b/product/dcf/OEM_Fleet/centari.pdf
 

·
Registered
Joined
·
312 Posts
Centari w/hardener wait a minimum of 72 hours, preferably a full week in a heated shop. Without hardener, strip it off now and start over. Centari without hardener will craze when repainted, even a year later.

Good luck with it.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top