Hot Rod Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I just installed a holley projection fuel injectoin on my 305sbc. Anyone done this? I know it is pumping too much fuel for my motor. I also know that I can reduce the pressure on the TBI unit and turn down the main dial. This is the 2 barrel digital version for V8's. I was going to install the air/fuel mixture monitor device that holley sells, but I wanted to make sure this setup will work. Future plans do call for a 350 but no $$$ for now.
 

·
Premium Member
Joined
·
2,370 Posts
You can mess with it somewhat to get the fuel down however the injector flow rate and the computer chip is what controls fuel distribution. It depends on how the fuel is mapped and for what engine its setup for. I imagine most are setup for the larger SBC's.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top