Hot Rod Forum banner
1 - 1 of 1 Posts

138 Posts
Discussion Starter · #1 ·
Hi guys!

I just ordered a Holley Sniper master kit to be installed in my sbc 383 powered 56 Chevy truck.

Do you think it is mandatory to drill the sending unit or the tank to install the supplied bulkhead fitting for the return line? I was thinking about putting a "tee" in the filler vent hose instead.

Will this cause any technical problems or annoying sounds?

The truck has got the in cab fuel tank. The filler looks like this:


1 - 1 of 1 Posts