Hot Rod Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
130 Posts
Discussion Starter · #1 ·
Hello all,
Any ideas on the best method to hook up my throttle cable. I did the usual searches and found the usual brackets on Summit and Jegs. They seem big and clumsy.

looking for some real experienced recommendations.

383 stroker, with AFR 195 heads, Edelbrock Performer RPM AIR gap intake, an AED built Holley 750 DPHP, in a 72 Nova with factory pedal, cable, and linkage.

here is a pic….

Circuit component Gas Motor vehicle Auto part Computer hardware
 

·
Registered
Joined
·
4,709 Posts
I used this bracket below for over ten years on my old truck I used to own and it does not look like much but it does the job and I never had any problems with it and it worked out fine with my factory GM cable and transmission kickdown cable on my th350.

 

·
Registered
Joined
·
1,154 Posts
I have used several of these on Holley and Edelbrock carbs for Lokar throttle, detent, and TV cables. They look great and work exceptionally well. 5 stars!

Automotive lighting Bicycle part Household hardware Tool Font


 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top