Hot Rod Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
774 Posts
Discussion Starter · #1 ·
Hydraulic roller 222/228 274/280 .494/.494 lift 110 LSA 110 ICL 57º overlap intake closes 67º ABDC

Hydraulic roller 228/228 280/280 .494/494 lift 110LSA 107 ICL 60º overlap intake closes 67º ABDC


Curious how these cams would act compared to each other in the same engine. Same intake closing point,3º different overlap,one installed straight up and the other 3º advanced,single pattern,dual pattern.

10.3 CR 383 SBC Vortec heads 6 inch rods.
 

·
Registered
Joined
·
12,338 Posts
one cam is split pattern,slightly smaller (shorter intake duration) they are very close to each other. The extra few degrees intake might allow more air in,both will flow about the same out. split duration cams usually help heads with weak exhaust ports.
no answer can be given accurately,the heads flow chart might help with the math.
 

·
Registered
Joined
·
774 Posts
Discussion Starter · #3 ·
I appreciate the reply. I agree, head flow numbers would be a factor.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top