Hot Rod Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,353 Posts
This belongs in the body exsterior section, but Jon will move it later. You can build one from sheetmetal or fiberglass. Send me a PM on what your looking to do and I'll tell you how.

HK
 

·
banned
Joined
·
1,083 Posts
Steel will work good... I cut my camaro hood along the body lines (the onese coming from inside the headlights) and then I lifted it 3 inches in the back (not alot but works good cuz of the width) then I added another peice off another camaro hood so I had an overhang over my window... That is at least how you make a cowel hood on a 3rd gen camaro
 

·
Registered
Joined
·
517 Posts
If you have the patience for it, you could pound out a custom cowl using a sand bag and rubber mallet. Take a look at the Metalshapers.org web site.
 
1 - 5 of 5 Posts
Top