Hot Rod Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
453 Posts
Discussion Starter · #1 ·
Does anyone have any recommendations on Ingersoll Rand Compressors. More specifically the one listed below. The price is right but I am not sure of the name. I would appreciate any help that you can provide. I was looking for a 60 gallon compressor but then one of the members told me about this 80 gallon unit for a good price. I am ready to get it but I would like to know a little more about the reliability.

Thanks

Dave

http://www.mytscstore.com/detail.asp?pcID=1&paID=1010&sonID=469&page=1&productID=9181
 

·
Premium Member
Joined
·
8,454 Posts
Are you asking if Ingersoll Rand is a good name?! I hope to shout it is! IR is one of the top two or three industrial tool makers in the world! I worked on a project that used 1,500 HP of electric motor driven IR 2-stage compressors and they ran nearly trouble free for 15 years and they were 40 years old when we got them! IR compressors have been used all over industry for nearly a century. If you can afford this unit, by all means buy it.
 

·
Registered
Joined
·
3,925 Posts
I would agree with Willys and n66ht about the IR compressor. However, you are in a price range where you might also want to consider a 2-stage unit. I just saw a Husky (Campbell Hausfeld makes these) 2-stage (80 gal, 175 max pressure, 15.1 @ 90) for $869 at the Local Home Depot. Also Sears has a Craftsman 2-stage (175 max, 17.4 @ 100, 16.9 @ 175) for $849.

I am also in the market for a new compressor and saw the IR you are looking at on Tractor Supply's web site. However, their nearest store is about 8 hours round trip from where I live - so I'm leaning toward one of the 2-stage units. It will actually end up cheaper for me than the single stage IR. But if you have a Tractor Supply nearby - you won't go wrong with the IR.

Dewey
 

·
Registered
Joined
·
5,920 Posts
Been- I would not be the least bit concerned about that tank since you have a 2 stage you have pump capacity and that is what counts, honestly an 80 gallon tank with that same compressor would make no noticeable difference and not one bit more air. With an 80 gallon tank your compressor would kick on and off less often(but run longer each time) making life a little easier on the pump and motor, that is what the bigger tank is for, but hardly enough to matter much. The 60 gallon tank will keep up with your tools just as good as the 80 since the compressor CFM would remain the same regardless of tank size and total air delivery would be equal for both tanks.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top