Hot Rod Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
So I am starting to revise the wiring in my 1970 C10. For the most part it is good shape . I just want to clean it up and get rid of the unnecessary equipment.
Question I have for the Gurus of the electrical world is. Where do I need inline fuses?
Do I need one going to my HEI? I have been reading it both ways on many different sites.
Also I installed a new Lokar kickdown switch. Does this need one?
If I do use inline fuses is there a rule of thumb as to which size fuse to use with certain size wires?

Thanks in advance for your help.
 

·
Registered
Joined
·
3,111 Posts
A fuseable link is a fuse...... slow-blow but still a fuse. I have my entire elec system, minus the starter, going thru a 70 amp maxi-fuse then to the fuse box etc.....
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top