Hot Rod Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4,775 Posts
Discussion Starter · #1 ·
Hell guys I am finally getting things back together on my sbc 350 and will get my timing cover gasketed up tomorrow along with my intake but I just set my valve lash on my lunati voodoo hydraulic roller cam and after zero lash I tightend 3/4 of a turn and was wondering if thats too much and also I have comp cams stud girdles to put on and any advice on installing them. I don't have the instructions on them and tried goodle and all I cam up with is the ones for 7/16 studs not the 3/8 ones I have. Do I have to redo all of my valve lash again after I install them? Thanks guys for all your help on here I have learned a lot over last year and was able to set lash with no problems.
Thanks
Eric
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top