Hot Rod Forum banner

intake manifolds

672 Views 13 Replies 9 Participants Last post by  55_327
I am getting ready to build a 360 sbc out of a 880 4 bolt block,its been machined lined ,decked bored,and I recently bought some aluminum heads for it ,these heads will fit either vortec style intake manifold or conventional ,my block does have third bypass hole for the water pump and mechanical fuel pump hole.To me it seemed simple to just set it up like old school 350 build but Im wondering if I might be missing something.or over thinking it,and another thing is Ive got my mind set on a air gap manifold,do I have to have it? motors going in a 4x4 jeep.there's other cheaper intake manifolds that do the same. other than the cooling part.I guess I should add that the runners are 200cc 68cc chambers,2.02 -1.64 valves,flat top forged pistons, .500/.510 cam, thank you
1 - 1 of 1 Posts

· Registered
Joined
·
271 Posts
I have tried just about every intake made, tunnel ram, airgap, rpm, and performer. For a street driven vehicle (sbc) with a cam under 270 degrees, Wait for it......stock older cast iron tall Quadrajet intake (No EGR) with Early Q-Jet carb. Great driveability and performance and about as simple as you can get. GM spent thousands of hours in research and development on this set up. IT works as long as you limit cam duration to acceptable limits for a street driven vehicle.
Just my opinion. Your mileage may vary.
 
1 - 1 of 1 Posts
Top