I'd go with Marine Tech. It is dog gone tough to remove.
intake runner epoxy
I'm looking at getting some epoxy to work on some heads with and I'm trying to decide between Manley, Moroso, or JB Weld. A lot of people raise an eye brow at JB, but its used in motorcycle ports a lot and I have yet to find any reported cases of failure. Has anyone used in in a port that had proper preperation and it failed?
1 - 3 of 3 Posts
epoxy
Get in touch with Rich at Ram Racing.
http://www.ramracing.us/products.htm
It is the best stuff out there for ports. The only way it comes off is with a grinder..L.O.L.
Tell him Keith from K-Star Automotive sent you.
Keith
Get in touch with Rich at Ram Racing.
http://www.ramracing.us/products.htm
It is the best stuff out there for ports. The only way it comes off is with a grinder..L.O.L.
Tell him Keith from K-Star Automotive sent you.
Keith
1 - 3 of 3 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Hot Rod Forum
A forum community dedicated to hot rod owners and enthusiasts. Come join the discussion about restoration, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
