Hot Rod Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
9,732 Posts
you will have trouble getting a louvre cut unless you have some good metal men locally. i have used the back panel from a commercial beverage cooler that was junked. some of the older ones have removable panels on the back so they can be serviced and the panels are vented, check out an old established heating and cooling co, or a scrap metal place. or sheet metal contractor.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top