Hot Rod Forum banner
1 - 2 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have a 75 MGB with a V8, rover 3.5, the old aluminum Buick 215. At any rate it can get pretty hot on a summers run over the BC mountians. I want to get some louvers cut into a piece of metal and weld them into the engine bay to dump some of that V8 heat. Does any one know where I could get some 6" luver (or 5") cut?

Brude
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #6 ·
Thanks All
A fellow in Portland has been located and I should have the 6" louvers this week.

Bruce
 
1 - 2 of 1 Posts
Top