Hot Rod Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
455 Posts
Discussion Starter · #1 ·
Am I going about this the right way...? I am building the area below my trunklid from scratch, the car is pro street, NOT stock. There is nothing left of the original rear whatsoever.
I rolled some light gauge square tubing, cut and welded it to exactly match the contour of the bottom of the trunklid. I have it mocked up with vise grips and 3/16" of spacers to simulate a lid gap. I am going to get the trunklid to fit perfectly as possible, then attach the bottom pice to the frame and start to build from there.
Is this what you guys would do?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top