Hot Rod Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
497 Posts
Discussion Starter #1
I am going to install a Must II crossmember in my 1948 GMC pick-up. I have new GM G-body metric calipers & rotors(10 1/2") & would like to use them on this project. Do I use the same bearings & seals on the Must II spindles as GM used on the G-body spindle or some thing else?........who is a good source to buy the caliper mounting brackets from?
 
1 - 2 of 2 Posts
Top