Hot Rod Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
338 Posts
Discussion Starter #1
I have an original, not newly fabricated, Mustang II front end on my '31 coupe. I need replace the flexible brake lines to each wheel. Can anyone tell me what kind/size fittings are on the ends of these hoses (ie,3-AN etc.)? I'd also appreciate any recommendation on where to get stainleses braided hoses as replacements. Thanks.
 

·
Registered
Joined
·
338 Posts
Discussion Starter #3
Thanks. I am not sure what calipers I have, but suspect they are the originals.
 

·
Registered
Joined
·
338 Posts
Discussion Starter #6
Thanks to alll. I went to the Fall Carlisle show today(gret,great show if you haven't been) and found out the end fitting the caliper is a 7/16" x 24 NPT. Just in case you need to know.
 
1 - 7 of 7 Posts
Top