Hot Rod Forum banner
Cancel

Need 1 3/8"x10spline x10.5" dia Clutch Friction Disc

811 Views 3 Replies 3 Participants Last post by  327amc, 
327amc
Im In the process of connecting this SBC to a ford trans.

So far, so good. Now I think i need a 1 3/8"x10spline x10.5" dia Clutch Friction Disc
Preferably high torque ceramic.

I have found that a 1940's ford flathead v8 was backed with such a disc but was 10" dia.
And according to Jegs, a 66' fairlane was backed with such a disc but was 11" dia.

Does a 1 3/8"x10spline x10.5" dia Disc exist?

Thanks in advance :D

Tractor Vehicle Agricultural machinery Auto part Engine
See less See more
Reply
Save
Like
1 - 4 of 4 Posts
2
Did you get a pressure plate yet ? Measure the plate diameter , there may be enough room for the 11" ? I doubt that running the 10" disc would cause any problem either ...
Reply
Save
Like
  • Like
Reactions: 1
johnsongrass1
www.clutchfab.com

Clutch Fabrication and Design

Custom steel design and fabrication business serving Bloomington, Indiana and surrounding areas.
www.clutchfab.com www.clutchfab.com
Makes a lot of custom clutches and are
good people to deal with.
Reply
Save
Like
  • Like
Reactions: 1
327amc
2old2fast said:
Did you get a pressure plate yet ? Measure the plate diameter , there may be enough room for the 11" ? I doubt that running the 10" disc would cause any problem either ...
Click to expand...
Havent got the pressure plate yet. Its a 1960 10.5" corvette pressure plate.
Reply
Save
Like
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Hot Rod Forum
A forum community dedicated to hot rod owners and enthusiasts. Come join the discussion about restoration, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Engine Hotrodders' Lounge Body - Exterior Transmission - Rearend Hotrodding Basics
Top