Hot Rod Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter · #1 ·
Does anyone make a headlight bucket for a sealed beam where the two alignment adjustment screws are accessed from the back side?

If that is not available, are longer adjustment screws available so I can make them accessible from the back side?

I'm eliminating the headlight bezel and having just the headlight retaining ring pass through the fender opening for a smoother look.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top