Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
hi new to site not stupid built a few hot rods lots of harley what i would like to know is i have 5 liter ford ho built for a blower with a ts 1000 blowzilla super charger with 8 psi boost made by kennebell i need to run taller valve covers so i want to put a 1 inch spacer between my upper and lower intake this is a efi motor with mass air what is this spacer going to change in performance and will it stand up its made by ford racing looking for what changes will it make rockers are hitting covers thanks howard
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top