Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 · (Edited)
I have a 1989 Chevy P30 step van. The engine blew last week and I need to replace it. It has a 5.7 ltr (350) 4 bolt main. I have had a couple of people tell me that you have to remove the front end of the vehicle to change the engine. It looks to me like that aluminum body is all riveted together. I need a good step by step manual before I start into this. Any suggestions?
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
Need to replace the engine in my P30

The only markings on the body are Chevrolet logos. It is an all aluminum body. I agree it would be difficult to get a cherry picker inside ... but I suppose, not impossible.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top