Hot Rod Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
676 Posts
Discussion Starter #1
Does anybody know about how much power this will make??
*302 block
*Ford Motorsport E303 roller cam (D: 220 @ .050 intake&exaust, L: .498 intake&exaust
*Stock pistons
*edelbrock RPM heads (1.90/1.60)
*crane 1.6 roller rockers
*9.5:1 compression
*Edelbrock RPM manifold
*Edelbrock 600 cfm carb
* K+N filter
* JBA shortie headers
* 2.5" flowmaster exaust
* NO smog equipment
Any advice would be helpful. Thanks.

[ March 11, 2002: Message edited by: mustang66maniac ]</p>
 

·
Registered
Joined
·
1 Posts
I have that exact same setup in my 86'capri but with hooker headers,steeeper cam weidland 6-71 blower that makes a dyno proven 731hp with nos

good choice

86'capri
 

·
Registered
Joined
·
18 Posts
I'seen combos simalar to this before that were in 300-350HP range I'm guessing that the lift of your cam is.303" . if you steepen the lift you should be able to boost your HP even more
 

·
Registered
Joined
·
676 Posts
Discussion Starter #4
The specs on the cam are... duration @.050 is 220 for intake and exaust. Lift is .498 for intake and exaust. (with 1.6 rocker arm) Hope that helps.
 
1 - 4 of 4 Posts
Top