Hot Rod Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Sonworld screen name. I am working on a 46 Hudson coupe chopped the top 2" ,Fat man front end, 9" ford rear on Air Ride. Just finished custom floor pans and chop window trim. My first project so still figuring it all out as I go. Anyone out there roded a Hudson? I sure could use some ideas on interior and under hood. I have a 383 Chevy motor and 350 trans. Would reall like to go fuel injected and an overdrive trans???I will post pics as soon as I figure out how to do it.
Regards to all my Rod friends
 

·
Hotrodders.com moderator
Joined
·
9,581 Posts
Welcome to the board.. :welcome: There are some who have done the Hudson..Most of it is jsut straight up "Rodding work"..Post your specific questions in the appropriate forum and folks can try and help..

Sam
 

·
Lost in the 60's
Joined
·
15,292 Posts
Welcome to the Hotrodders Bulletin Board. There are lots of opinions, advice, and info here, as well as a lot of good natured fun. So jump on in and enjoy the site. :welcome:
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top