Hot Rod Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Ive just purchased a '63 4dr Impala that I am going to rebuild, though I may have gotten in over my head, only time will tell.
The body is straight with only a few dents and rust, but its not the original engine and I am now thinking of putting in a 383.
Any help yall can offer me on my project is appreciated.
 

Attachments

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thank you

Just got done pulling out the motor and tranny. Up till now we couldnt figure out why there was a huge cut in the floorpan where a shifter would go. Well, someone didnt tighten down the tranny to begin with so the drive shaft was bouncin up and down and eventually wore through. I know I will find many more gems like that on this car.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top