Hot Rod Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hey guys...

I actually found this place, looking for information on google about rebuilding my Michelin Floor Jack I got from Sam's Club a few years ago. :embarrass

http://www.hotrodders.com/forum/floor-jack-rebuild-95271.html

Thought I might as well sign up.

Currently I have a 94 Mustang GT with the following mods:

3,000 Street Edge Converter, TransGo shift kit, 3.73s, Cobra Intake, 75mm pro-m M/A, 24lbers, 65mm TB, MagnaFlow mufflers, O/R h-pipe, performance chip, Eibach drag springs, 255lph fuel pump, Mac pullies

Fall of 2006 numbers:
14.07 @ 96.86
12.79 @ 107.14 - 125 shot of Zex



After 5 years of spraying the car, it finally wore the rings out and lost compression. It was down to 115 across the board... 1.5 years ago. :D

A 331 with the TrickFlow Track Heat top end kit is waiting to go in. I just need to get the dumb thing off of my jack stands. :cool:
 

·
Registered
Joined
·
1 Posts
Michelin Jack

I have a 3 ton Michelin floor jack that I bought at Sam's a year or so ago. It crapped out almost immediately, and won't lift. Does anyone know where to get a rebuild kit for it, or where to obtain instructions to rebuild it? I see a lot of posts about it, but no answers. Thanks for any ideas :rolleyes:
 
1 - 3 of 3 Posts
Top