Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 ·
I'm running a 401 Buick Nailhead in my street rod. I have about 5K miles on the engine and have had not troubles. I decided to install a oil temp gauge and placed the temp sender in the aluminum oil filter adaptor where it will get a good flow of oil over it. I was surprised at the temp when on the road 275-280. Seemed like a logical place to put the sender but that temp is too high. Could it be the sender location?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top