Hot Rod Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
148 Posts
If it where me I would do all the body work and prime with a good 2 part primer then block sand with 220 grit paper then 320 dry sand the primed area fill all the rock chips with evercoat polyester puttie then wet sand the car with 1000 grit paper and stochbrite around the edges then you are ready to seal and paint
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top